View demo:  https://youtu.be/X1NFIS5uukk


  • QUICKPATCH is a fibreglass reinforced polyester patch which is pliable in the package and cures hard by applying UV light.
  • QUICKPATCH is easy to apply, there is no mixing, no weighing, no mess.
  • QUICKPATCH has great adhesion properties for long-lasting repairs
  • QUICKPATCH is non-flammable, non-toxic and the adhesive is not harmful to skin

What Can QUICKPATCH be used for?

When it comes to quick long lasting repairs, the question really is, 'what can't QUICKPATCH be used for'?  Here are only some of the examples of what QUICKPATCH is used for:

Home DYI

  • Eavestrough repairs
  • Plumbing repairs
  • Concrete stair repairs
  • Railings
  • Heating ducts
  • Hot tub and spa
  • Automotive


  • Camping & RV
  • Trailer repairs
  • Kayak & canoe repairs
  • Jet Ski, sail boats, SUP boards


  • Plumbing
  • Electrical
  • Pipes
  • Automotive
  • Agriculture equipment
  • Trucks and trailers

Application Method in Direct Sunlight

  1. The surface needs to be clean, dry and free of any contaminates. No oil or water in particular.
  2. Remove the QUICKPATCH from its protective foil pouch and cut to size required without exposing it to UV/Sunlight.
  3. Place the unused portion back into the protective foil pouch and seal.
  4. Remove the white backing tape on the patch material to expose the adhesive resin.
  5. Apply QUICKPATCH – sticky side down – to the area to be patched and press down firmly all over the patch and especially around the edges
  6. Remove the clear/transparent film on the back of the patch and expose it to the sunlight.

N.B. Curing time is totally dependent on the UV intensity at the time of application – from 5 minutes (sunny conditions) through to 50 minutes (overcast).

Application Method for Indoors or Indirect Sunlight

  1. QUICKPATCH is UV light activated so in applications where you are working indoors or in shaded areas out of direct sunlight, it will be necessary to activate the adhesive and curing process using a UV light/torch.
  2. Simply apply QUICKPATCH as per the instructions above and then, once the clear transparent film is removed, pass the UV light/torch over the patch until it sets.
  3. This may take a few minutes depending on the strength of the beam in the light/torch.




Webcom Supply Calgary, Alberta, Canada  Tel: 403-554-7795 Fax: 403-770-8500 Email: pbaril@webcomsupply.com